How to make Santa Hat Chair Covers
如何做圣诞帽椅子套
1 Get ready for the materials
准备材料
Felt: Maybe 4 yards of the red and 1 yard of the white
毛毡：（这啥单位……寸？）
It depends on the size of your chairs.
这取决于你椅子的大小。
2 Measure your chair
测量椅子大小
You need to know how wide it is (at it’s widest) and then how tall the back section is.
你需要了解椅子的最宽宽度以及椅背部分的高度。
In case of someone sat in the chair and pulled the chair cover down a bit and then sat on the cover, you'd better reach down to about 2 inches above the seat section of the chair.
以防有些人坐在凳子上时由于椅套微长坐在套上，高度最好是量到椅子上两英寸。
3 Make the main shape of cover into a rectangle and the top edge into a triangle(for the santa hat look)
将椅套的主体做成长方形顶端部分做成三角形（为了最终形成圣诞帽的形状）
Sew along all of the edges except for the bottom, using a 1/2 inch seam allowance.
将边缘除了底部全部缝合，每个缝合处1/2英寸的距离。
4 Trimmed off the 3 points
剪去三角
5 Turned it right side out and ironed (not too hot) flat.
翻转过来用熨斗熨平（不宜过烫）
6 Sew a straight line across the top of the chair cover, right where the triangle shape and the rectangle shape meet. This will keep the chair cover in place and will stop the cover from sliding down the chair.
在三角与长方形接合出缝出一条直线。这能让椅套保持固定以防从椅子滑落。
7 Cut a 2.5 inch wide piece of white felt that is the same width at the bottom of the chair cover, plus a 1/2 inch at each end, for the seam allowance.
剪下一段2.5英寸宽的白色毛毡，长度与椅套同宽，环在椅套上，底部仍留下1/2英寸距离。
8 Sew the two ends together
将两片毛毡底部缝合
9 Cut long strips of the white felt, about a 1/3 inch wide. Then I cut those long strips up into about 4 inch long pieces.
剪下长条白色毛毡，每条约1/3英寸宽。然后再把它们剪成每条4英寸左右长。
10 Wrap a long piece of thread around the middle of my felt strips and pulled tight. Then wrapped a few more times and knotted it several times. Then, I fluffed up the pieces and it turned into more of a pom-pom shape.
用一条长线从一把毛毡条的中间系上，并且系紧。然后多卷几次打几次结。然后将它们打乱成蓬松状。
11. Finished
成品。